Product Range

»

It may break under thermal stress in the steady state, that is when there is established constant thermal gradient through the glass.

»

It may break under the transient stress of a 'thermal shock', that is sudden heating or cooling.

»

It may, if heated beyond certain temperature, acquire a permanent stress on cooling which could cause subsequent failure.

Never leave vessel unattended when evaporation work is being carried out. The vessel may crack or explode as dryness condition is approached if the heat source is not adjusted correctly. Lower the temperature gradually as the liquid level drops.

Always use caution when removing glassware from a heat source and avoid placing on a cold or damp surface. Although the ware can withstand extreme temperatures, sudden temperature changes may cause the vessel to break.

Always cool vessels slowly to prevent thermal breakage.

Never apply heat to badly scratched or etched vessel as the thermal strength will have been greatly reduced.

Never apply point source heating to a vessel as this will greatly increase the chance of breakage.

Always diffuse the heat source by using a metal gauze or air/water bath. Alternatively ensure even heating of the vessel by slow movement of the vessel in relation to the heat source.

Adjust Bunsen burner to get a large soft flame. It will heat slowly but also more uniformly. Uniform heat is critical factor for some chemical reactions.

Ensure that the flame contacts the vessel below the liquid level. Heating above that level will invite breakage of the vessels.

Always use anti-bumping devices in the vessel, such as powered pumice or glass wool rapid heating of the vessel and contents is required.

Never use material with sharp edges such as broken porcelain as an anti-bumping device. This will cause internal abrasions and reduce the mechanical and thermal strength of the vessel.

Thick walled glassware should not be subjected to direct flame or other localised heat source. Vessels of this type are best heated with the use of an electric immersion heater.

Avoid heating glassware over electric heaters with open elements. Uneven heat of this type can include localised stress and increase the chance of breakage.

Remember that the hot plate will retain heat long after the appliance has been switched off.

Always ensure that the surface of the hot plate is larger in area than the base of the vessel being heated. An under-sized plate of the job in hand will invite uneven heating and promote breakage of glassware.

15.

Always ensure that manufacturer's instructions are Bollowed when electrical heat sources.

Never use a glassware beyond the recommended safe limit.

Always use a safety screen when working with glassware subjected to pressure of vacuum,

Never subject glassware to sudden pressure changes. Always apply and release positive and negative pressures gradually.